A little more room to unfold.

Enlarge this napplet to at least 280 × 280. Your model and edits stay here.

Faceted gem

3D model

DRAG TO ORBIT · TAP TO SELECT

2D pattern

A4 · mm
Sheet 1 / 1
Ready

From mesh to paper

  1. Open an OBJ or STL. Up to 2,000 triangles and 8 MiB. A sample gem is ready to try.
  2. Set the longest dimension in millimetres. OBJ/STL do not reliably specify units; confirm your intended finished size.
  3. Explore the model. Drag to orbit; Shift-drag or right-drag to pan. Scroll or pinch to zoom. Select a face to locate it in both views.
  4. Choose Cut / join. Click a shared edge in either view. Seam changes rearrange pieces. Overlapping joins and cycles are refused.
  5. Move pieces on the sheet. Drag in Move mode, or use the X, Y, rotation and sheet fields in Tools. Arrange packs the pieces again.
  6. Adjust tabs. In Tabs mode, click a cut edge to switch its tab side. Tools also changes tab depth, taper and visibility. Tabs that collide are shortened or omitted; inspect warnings.
  7. Preview and export. Fix any off-page or overlapping pieces, export PDF, then download from the host's file panel. Print at 100% / Actual size. The reference bar must measure 20 mm.

Save project exports an editable .nappakura file. Save draft uses optional host storage. Unsaved edits remain only in this session. Open surfaces may need manual fold-direction checks.